Method/Step 1:
First, make sure that the nail polish or nail polish glue applied before is completely dry, and then remove it, otherwise it will be damaged. Use a rhinestone pen or tweezers to clamp the drill to be pasted into the triangular plate, do not touch the drill surface with your hands
Method/Step 2:
Use a toothpick or pinhole glue to apply glue or model glue or crystal powder and crystal liquid to the position where the rhinestone needs to be attached. It is recommended to use glue or model glue for small drills, and crystal solution for large rhinestones with transparent crystal powder or phototherapy transparent glue. , the glue does not need to be too thick, a uniform thin layer is enough. Be sure to control the amount of glue, otherwise the extra part will be very ugly to form offset printing.
Method/Step 3:
Use a drill pen to stick the rhinestones on the glue. The glue will not dry immediately. If the position is not right at this time, we can move it slightly. But be careful when moving, don't move the excess glue to the blank place, the offset printing will be ugly, and don't make the surface of the rhinestone stick to glue or nail polish, which will affect the brightness of the drill.
Method/Step 4:
Press the drill down with an orange stick until the glue dries out. If you want to be more reliable, you can also add a little model glue or crystal powder with crystal liquid or phototherapy transparent glue around the rhinestones. If the head of the crystal pen is too thick, you can use a carving pen to make up. It is recommended to do the same for the rhinestones. Be sure to wash it with pen water. If you use model glue, you need to take one more step to dry it at this time. The glue and crystal liquid will dry by themselves and do not need to be photographed.
Method/Step 5:
If the diamond is not too big, you can stick the diamond first and then apply the sealing layer, it will not be easy to fall off. When brushing the sealing layer, it is better to apply the brush back and forth several times at the position where the rhinestone is attached, it will be more difficult to fall off. . In fact, as long as there is no problem with the sealing layer, it will not affect the brightness of the rhinestones, so you don't have to worry too much If the rhinestones are too large, it is recommended to seal the layer first and then stick the rhinestones.
